Dayton Services is known for offering top-quality Cedar Park, TX HVAC services, but did you know we provide second-to-none plumbing and electrical services too?
Read our reviews below to find out why Cedar Park, TX residents turn to our HVAC technicians, plumbers and electricians over and over again.
Local Reviews
for Cedar Park, TX
Powered by Nearby NowOur Reviews by City
Excellent, Prompt Service
Alex - Cedar Park, TX
Great service
Donnie - Cedar Park, TX
Jared S.
I am replacing a condenser fan motor on a Daikin a/c unit.
Chris V.
On arrival performed 2 System maintenance recommended 2 a/c serge protectors
Chris V.
On arrival performed 2 System maintenance recommended 2 a/c serge protectors
Chris V.
Chris V.
Bradley E.
Performing the installation of a gas line to supply an outdoor barbecue grill. We do remodel gas work as well as remodel plumbing.
Bradley E.
Performing a free estimate to install a gas line for an outdoor grill. And we perform repairs and installs of natural gas and propane piping.
Chris V.
Serviced a Amana air conditioner
Chris V.
Serviced a carrier air conditioner
Chris V.
Serviced a goodman a/c recharged system & replaced capacitor
Chris V.
Perform service on a Goodman heat pump
Joshua T.
Ac repair in Cedar park
Colter F.
Perform fall preventative maintenance inspection on two Carrier gas furnaces.
Joshua T.
Ac drain repair in Cedar Park
Joshua T.
Home air-conditioning repair in Cedar Park
Colter F.
Replace bulb for anti-microbial UV lamp and air filters for home owner.
Bobby W.
Replaced blower motor replacement on a York air conditioning system
Bobby W.
Replaced blower motor replacement on a York air conditioning system
Joshua T.
AC repair in Cedar park
Javier V.
Check 8yr old carrier system found bad capacitor clogged drain replace the capacitor everything running well
Joshua T.
AC maintenance and repair in Cedar Park Texas
Joshua T.
Customer was complaining about a loud whistling noise coming from the AC system. Source of the problem was a dirty filter. Replace filter with a new one--system is working properly at this time.
Joshua T.
Checking the performance of a furnace. Found a label from one of the panels was hindering the fan. Removed the label from the fan and the furnace worked properly. Recommended CO detectors.
Joshua T.
Checking the performance of the furnace. Diagnosis was a dirty flame sensor. Clean the flame sensor--this is a temporary fix. Sensor will eventually stop working. Recommended a 3.5 ton up flow gas furnace along with a supply plenum and potential duct work.
Joshua T.
Perform a fall preventative maintenance inspection. All components are working properly. Recommendation: Installation of UV Light(s).
